Set-Up Adjustments; 2-1. Beam Landing - Sony TRINITRON KV-32HS20 Service Manual

The following adjustments should be made when a complete
realignment is required or a new picture tube is installed.
These adjustments should be performed with rated power supply
voltage unless otherwise noted.
The controls and switch should be set as follows unless otherwise
noted:
VIDEO MODE: STANDARD (RESET)

2-1. BEAM LANDING

Preparation:
• Input a white pattern signal.
• Face the picture tube in an East or West direction to reduce the
infl uence of geomagnetism.
NOTE: Do not use the hand degausser; it magnetizes the CRT .
1. Input white pattern from pattern generator. Set the PICTURE control
to maximum, and the BRIGTNESS control to standard.
2. Perform Focus, G2 and White Balance adjustments.
3. Loosen the defl ection yoke mounting screw, and set the purity control
to the center as shown below:
Purity Control
4. Input a green pattern from the pattern generator.
5. Move the defl ection yoke backwards, and adjust with the purity
control so that green is in the center and red and blue are even on
both sides.
SECTION 2: SET-UP ADJUSTMENTS
Blue Red
Green
KV-32HS20/36HS20/36HS20H/32XBR450/36XBR450/36XBR450H
Perform the adjustments in order as follows:
1. Beam Landing
2. Convergence
3. Focus
4. Screen (G2)
5. White Balance
Test Equipment Required:
1. Color Bar Pattern Generator
2. Degausser
3. DC Power Supply
4. Digital Multimeter
6. Move the defl ection yoke forward, and adjust so that the entire screen
becomes green.
7. Switch over the raster signal to red and blue and confi rm the
condition.
8. When the position of the defl ection yoke is determined, tighten it with
the defl ection yoke mounting screw.
9. If landing at the corner is not right, adjust it by using the disk magnets.
Disk magnets
or rotatable disk
magnets correct
thses areas (a-d)
b
d
— 10 —
Purity control
corrects this area
Deflection yoke positioning
corrects these areas
a
c