Dell OptiPlex 9010 Owner's Manual page 55

Error Message
Gate A20 failure
General failure
Hard-disk drive configuration error
Hard-disk drive controller failure
Hard-disk drive failure
Hard-disk drive read failure
Invalid configuration information-
please run SETUP program
Invalid Memory configuration, please
populate DIMM1
Keyboard failure
Memory address line failure at
address, read value expecting value
Memory allocation error
Memory data line failure at address,
read value expecting value
Memory double word logic failure at
address, read value expecting value
Memory odd/even logic failure at
address, read value expecting value
Memory write/read failure at address,
read value expecting value
Memory size in CMOS invalid
Memory tests terminated by keystroke A keystroke interrupted the memory test.
No boot device available
No boot sector on hard-disk drive
No timer tick interrupt
Non-system disk or disk error
Not a boot diskette
Description
One or more memory modules may be faulty or improperly seated. Reinstall
the memory modules and, if necessary, replace them.
The operating system is unable to carry out the command. This message is
usually followed by specific information—for example, Printer out of paper.
Take the appropriate action to resolve the problem.
The hard drive failed initialization.
The hard drive failed initialization.
The hard drive failed initialization.
The hard drive failed initialization.
The computer configuration information does not match the hardware
configuration.
DIMM1 slot does not recognize a memory module. The module should be re-
seated or installed.
A cable or connector may be loose, or the keyboard or keyboard/mouse
controller may be faulty.
A memory module may be faulty or improperly seated. Reinstall the memory
modules and, if necessary, replace them.
The software you are attempting to run is conflicting with the operating
system, another program, or a utility.
A memory module may be faulty or improperly seated. Reinstall the memory
modules and, if necessary, replace them.
A memory module may be faulty or improperly seated. Reinstall the memory
modules and, if necessary, replace them.
A memory module may be faulty or improperly seated. Reinstall the memory
modules and, if necessary, replace them
A memory module may be faulty or improperly seated. Reinstall the memory
modules and, if necessary, replace them.
The amount of memory recorded in the computer configuration information
does not match the memory installed in the computer.
The computer cannot find the floppy disk or hard drive.
The computer configuration information in System Setup may be incorrect.
A chip on the system board might be malfunctioning.
The floppy disk in drive A does not have a bootable operating system installed
on it. Either replace the floppy disk with one that has a bootable operating
system, or remove the floppy disk from drive A and restart the computer.
The operating system is trying to boot to a floppy disk that does not have a
bootable operating system installed on it. Insert a bootable floppy disk.
55