Installing The System Fan
1.
Place the system fan in the chassis.
2.
Pass the four grommets through the chassis and slide outward along the groove to secure in place.
3.
Thread the system fan connector cables to the chassis clips.
4.
Connect the system fan cable to the system board.
5.
Thread the power cables to the chassis clips.
6.
Connect the 24–pin connector.
7.
Install the hard drive.
8.
Install the optical drive.
9.
Install the front bezel.
10. Install the cover.
11. Follow the procedures in
Removing The Thermal Sensor
1.
Follow the procedures in
2.
Remove the
a) cover
b) front bezel
c) hard drive
After Working Inside Your Computer .
Before Working Inside Your Computer .
29