Pride Mobility Quantum Jazzy series Owner's Manual page 36

V I I . C A R E A N D M A I N T E N A N C E
BATTERY QUICK-CONNECTOR
Figure 19. Quantum Jazzy 1650 Battery Connections (4-Battery Configuration)
Figure 20. Battery Wiring Diagram (4 Batteries) Figure 21. Battery Wiring Diagram (2 Batteries)
To replace the batteries:
1. Turn off the power to the controller.
2. Make sure that the power chair is in drive mode. See III. "Your Power Chair."
3. Unplug the controller communications cable from the power base.
4. Remove the seat.
5. Lift off the shroud
6. Unplug the battery quick-connector from the powerbase. See figure 19.
7. Remove the old batteries.
8. Disconnect the wiring harnesses from the batteries. See figures 20 and 21.
9. Connect the wiring harness to the new batteries.
WARNING! Make sure you tighten the fasteners so that the connections are secure.
36 www.pridemobility.com Quantum Jazzy 1650 Series