Operating Your Radio - Search Tuning Fm - Sangean DCR-10 Manual

Operating your radio – Search tuning FM
1. Fully extend the FM wire spring aerial.
2. Press the Standby/Sleep button to switch on your radio.
3. Press and release the Source button until the FM band is selected.
4. Press and release the Select button to cause your radio to scan
in the direction upwards and stop automatically when it finds a
station of sufficient strength.
5. After a few seconds the display will update. The display will
show the frequency of the signal found. If the signal is strong
enough and there is RDS data preset then the radio will display
the station name.
6. To find additional stations press and release the Select button
as before.
7. When the end of the waveband is reached your radio will
recommence tuning from the opposite end.
8. Adjust the Volume control to the required setting.
9. To switch off your radio press the Standby/Sleep button.
2
3
4,6
8
GB
22