Operating Your Radio For The First Time - Dab - Sangean DCR-10 Manual

Operating your radio – DAB+
1. If your radio is in standby mode, press the Standby/Sleep button
to switch it on.
2. Press and release the Source button to select DAB+ mode.
The display will show "TUNING" for a few seconds.
3. If this is the first time the radio is used a quick scan of the
DAB+ channels may be carried out (depending on whether
scanning was already completed in standby mode.) If the radio
has been used before, the last used station will be selected.
4. When first switched on, the first station in the list of stations will
be shown. Press the Select button to tune to this station or
rotate the Tuning control to select an alternative station.
The display will show the station name on the lower line of the
text display.
5. If the stations list is still empty after the scan operation or if the
selected station cannot be received your radio will display
"OFF AIR".
6. If no signals are found it may be necessary to relocate your
radio to a position giving better reception.
Note that radio station name and frequency displays shown in this
user guide may differ from those that you see on your radio.
Broadcasters may change radio station names that are transmitted,
and the frequencies used for DAB+ and FM radio stations may not
be the same in all parts of the country.
2
GB
12