Step 3: Route The Cables - LevelOne FCS-3072 Hardware User Manual

Step 3: Route the Cables

Determine whether the cable will pass through a hole on the surface or be routed along the
surface:
If the cable will pass through a hole on the surface:
1. Drill the hole for the cable on the surface.
Drill cable hole
within this block.
2. Route the cable from the network side through the hole and connect it to the Ethernet port of
the camera.
NOTE: If the camera will be installed outdoors or in places wherein environmental factors
change drastically, make sure to waterproof the cable connection; see
the Cable Connection
3. Push the cable through the the hole on the surface.
If the cable will be routed along the surface
1. Pull the tab to slide it off from the dome cover.
2. Route the camera cable through the gap on the camera cover.
Hardware Manual
on page 16 for instructions.
14
Step 5: Waterproof