Control; Remote Control; Onboard Interface - Paradigm soundtrack 2 Setup Manual

Step 4
a) If a wall stud is found, drill a pilot hole into the stud at each mark,
then move to Step 5. OR
b) If no stud is found, install wall anchors at each mark following the
instructions for the type of wall anchor you are using. CAUTION:
We strongly recommend contacting a professional contractor
for this type of installation.
Step 5
Fig. 5
Using the screws, attach the first wall bracket
to the wall. DO NOT completely tighten
screws (Fig. 5).
Step 6
Repeat steps for the second bracket. Use a
level to make sure the brackets are completely
straight before tightening all screws.
Step 7
IMPORTANT: Attach audio cables BEFORE mounting soundbar to
wall brackets. See Set-Up Guide for how to attach cables.
Move soundbar into place directly over brackets and gently push it to the
wall making direct contact with brackets. You will hear a CLICK as each
bracket makes contact with the soundbar. DO NOT release soundbar
from your grasp until you hear those two clicks.

CONTROL

Remote Control

The supplied remote includes 2 x AAA batteries. Follow the diagram on
the back of the Remote for correct insertion: + to + and – to -.
Power
On / Off
Volume Up
Volume Down
Input
MODE
IMPORTANT:
If you lose the remote, contact Paradigm at 1-905-696 2868
to purchase a new one. Loss of remote is not covered under
Paradigm warranty.
Soundbar Top-Panel Controls
Press to turn Press to Press to synch
system select soundbar and
on and off Source subwoofer
Mute Next Track
Enable
Movie Mode*
Bluetooth
Play / Pause Music Mode*
* Sonic enhancements
Previous Track to listening experience
according to mode.
Press and Press and
release to release to
decrease increase
volume volume
EN – 6
EN