Units; Job History; History Size; Network - KIP C7800 Operator's Manual

KIP C7800 Touchscreen Software

Units

Set the system from "English Mode" to "Metric Mode" by selecting the English or
Metric button. This will change the output KIP System to that unit of measure.
Please note that the printer must be set to the correct size mode for proper print
function.

Job History

Enabling or Disabling the Job History button has no function at this time and does
not affect the system.

History Size

If Job history is On the History size will be set to 25 gig (20 % of the hard drive) If the
History Size button is set to Off then the ability to print from history from KIP Print or
KIP PrintNet will be disabled.

Network

When setting up the KIP Printer on the Network at the site the KIP comes already
pre-configured for DHCP (Dynamic Host Configuration Protocol) and if plugged
into the network will automatically receive an IP Address
from the DHCP Server.
If the Site is not using a DHCP server to dish out IP address it
will be necessary to assign a Static IP Address (select the
Manual Entry button) to the KIP Printer. The onsite network
administrator will need to supply all of the valid information
for the IP Address scheme that will be applied to the KIP
Printer.
This information is solely for use of KIP Personnel and KIP Authorized Dealers. No part of this publication may be copied,
reproduced or distributed in any form without express written permission from KIP.  2012 KIP. vii_iv
16