Maintenance And Service; Maintenance And Cleaning; After-Sales Service And Customer Assistance - Bosch 14,4 V Original Instructions Manual

OBJ_BUCH-639-002.book Page 21 Friday, December 4, 2009 2:00 PM
Excessive feed reduces the surface quality and
can lead to rapid clogging of the chip ejector.
Only sharp blades achieve good cutting capacity
and give the machine longer life.
Beveling Edges (see figure H)
The V-grooves in the front planer base plate al-
low quick and easy beveling of workpiece edges.
Depending on required bevel width, use the cor-
responding V-groove. For this, place the planer
with the V-groove onto the edge of the work-
piece and guide it along the edge.
Groove to be
used
none
small
medium
large
Planing with Parallel/Beveling Guide
(see figures E–G)
Mount the parallel guide 19 or beveling guide 23
to the machine using the corresponding fasten-
ing bolt 22. Depending on the application,
mount the rebating depth stop 26 with fasten-
ing bolt 25 to the machine.
Loosen the locking nut 21 and adjust the re-
quested rebating width on the scale 20. Tighten
the locking nut 21 again.
Adjust the requested rebating depth according-
ly with the rebating depth stop 26.
Carry out the planing procedure several times
until the requested rebating depth is reached.
Guide the planer applying sideward supporting
pressure.
Beveling with the Beveling Guide
When beveling rebates
and surfaces, adjust
the required slope an-
gle with the angle ad-
justment 24.
Bosch Power Tools

Maintenance and Service

Maintenance and Cleaning

Before any work on the machine (e. g. main-
tenance, changing the tool, etc.) as well as
during its transport and storage, lock the
On/Off switch in the off position. There is
danger of injury when the On/Off switch is
unintentionally actuated.
For safe and proper working, always keep
the machine and ventilation slots clean.
If the machine should fail despite the care taken
Dimension a
in manufacturing and testing procedures, repair
(mm)
0 – 2.5
should be carried out by an after-sales service
1.0 – 3,5
centre for Bosch power tools.
2.0 – 4,0
2.5 – 5.0
In all correspondence and spare parts order,
please always include the 10-digit article
number given on the type plate of the machine.
After-sales Service and Customer
Assistance
Our after-sales service responds to your ques-
tions concerning maintenance and repair of your
product as well as spare parts. Exploded views
and information on spare parts can also be
found under:
www.bosch-pt.com
Our customer service representatives can an-
swer your questions concerning possible appli-
cations and adjustment of products and acces-
sories.
Great Britain
Robert Bosch Ltd. (B.S.C.)
P.O. Box 98
Broadwater Park
North Orbital Road
Denham
Uxbridge
UB 9 5HJ
Tel. Service: +44 (0844) 736 0109
Fax: +44 (0844) 736 0146
E-Mail: boschservicecentre@bosch.com
English | 21
2 609 932 745 | (4.12.09)