Disengaging Awd - Polaris 2013 RANGER 500 Midsize Owners Manual/Install Manual

OPERATION
All Wheel Drive (AWD)
The illuminated amber AWD switch indicates that the vehicle is in AWD.
When the AWD switch is on, the front gearcase will automatically engage any time the rear
wheels lose traction. When the rear wheels regain traction, the front gearcase will automati-
cally disengage. There is no limit to the length of time the vehicle may remain in AWD.
Initially, the vehicle's electronic system will not enable the AWD until the engine RPM is
below 3100. Once enabled, the AWD remains enabled until the AWD switch is turned off. If
the switch is turned off while the front gearcase is moving, it will not disengage until the rear
wheels regain traction.
Engage the AWD before getting into conditions where front wheel drive may be needed. If
the rear wheels are spinning, release the throttle before switching to AWD.
NOTICE: Switching to AWD while the rear wheels are spinning may cause severe drive shaft and
clutch damage. Always switch to AWD while the rear wheels have traction or are at rest.

Disengaging AWD

Under certain conditions, it may be possible for the front gearcase to remain locked unneces-
sarily. This condition causes increased steering effort and some vehicle speed restriction. If
the front gearcase remains locked after following these instructions, return the vehicle to
your dealer for service.
1. Stop the vehicle.
2. Operate in reverse for at least 10 feet.
3. Stop completely.
4. Shift into low gear and drive forward.
41