Polaris 2013 RANGER 500 Midsize Owners Manual/Install Manual page 32

FEATURES AND CONTROLS
Instrument Cluster
Rider Information Center
Diagnostic Mode
Miles/Kilometers toggle
The display in the tripmeter and odometer can be changed to display either standard or met-
ric units of measurement.
1. Enter the diagnostic mode.
2. Toggle to the screen that displays either kilometers (KM) or miles (MP).
3. Press and hold the mode button until the letters flash, then press and release the button
once. When the display stops flashing, the mode has been set.
Accessing Blink Codes
The EFI diagnostic mode is for informational purposes only. Please see your Polaris dealer
for all major repairs.
See page 29 for Blink Codes and Failure Descriptions. Use the following procedure to access
blink codes (failure codes) from the EFI module.
1. Apply the brakes.
2. Place the transmission in PARK.
3. Stop the engine.
4. Turn the key switch to the ON position.
5. Turn the key switch off and on three times in less than five seconds, then leave the
switch on. Any blink code numbers stored in the EFI module will display, one at a time,
on the screen. The number "61" and the word "END" displays after all codes have been
transmitted.
28