Desa CDR3924NT Owner's Operation And Installation Manual page 15

1. Place middle log (#1) onto log alignment
screw located near the center of base
and in place over log support bracket as
shown in Figures 17 and 18.
2. Place front log (#2) onto base. Position log
onto two alignment screws to the front of
base (see Figure 18).
3. Place left side log (#3) onto two log align-
ment screws on left side of base (see
Figure 18).
4. Place right side log (#4) onto two log
alignment screws on right side of base
(see Figure 18).
5. Place rear log (#5) onto two alignment
screws to the rear of base (see Figures
17 and 19).
Left Log
Front
Log
Middle
Front
Log
Log
Figure 17 - Log Alignment Screws
Left Log #3
Figure 18 - Installing Middle Log #1, Front
Log #2, Left Log #3 and Right Log #4
122270-01D
INSTALLATION
Rear Log
Right
Log
Log Support Bracket
Middle
Log #1
Front
Log #2
Right
Log #4
www.desatech.com
Continued
6. Place crossover log (#6) onto log align-
ment pin on middle log (#1) and rear log
(#5) (see Figure 19).
Crossover
Log #6
Rear
Log #5
Figure 19 - Installing Rear Log #5 and
ATTACHING GRATE TO BASE
ASSEMBLY
Locate the two slots in the front of the base
assembly. Carefully slide the decorative grate
into these slots (see Figure 20).
Grate
Figure 20 - Attaching Grate to Base
ADDING LAvA ROCK
Place lava rock around base of heater if de-
sired. Be sure not to cover the control knobs
or air inlet openings on the front of heater.
Crossover Log #6
Slots in Base
Assembly
15