How To Change Network Settings; Connecting Monitor, Keyboard, And Mouse; Disabling Write-Protection - FOR-A MBP-100MP64G Operation Manual

4. How to Change Network Settings

The Windows Operation System (Microsoft Windows XP Embedded) is installed in the
MBP-100MP. There are a few cases in which users will need to change network settings in order to
use the MBP-100MP over a network. This section describes how to change the computer name
and IP address for such cases.
The C drive is write-protected to enable the MBP-100MP to be powered on or off without
shutting down. The write protection on the C drive must be disabled to change the
computer name or IP address.

4-1. Connecting Monitor, Keyboard, and Mouse

To change settings on the MBP-100MP, connect a VGA monitor, keyboard and mouse as
shown below. (A VGA monitor, keyboard and mouse need to be purchased separately.)
VGA monitor

4-2. Disabling Write-Protection

1. When you power on the MBP-100MP, Windows and the listed start-up programs
automatically start. Close all programs.
2. Double-click the ewf_disable.bat in D:\forawork to execute the batch file.
3. Command Prompt opens and shows the following message. Press any key on the keyboard
once.
***************************************************************************
The write-protection (EWF) for the boot drive(C:) is set to enable.
The any driver cannot install when write-protection is enabled.
***************************************************************************
Press any key to continue . . .
MBP-100MP
VGA LAN2 LAN1 USB4 USB3
VGA cable
10
USB cable
Mouse
USB cable
Keyboard