Stopping The Engine; Driving Procedure - Polaris BRUTUS Owner's Manual For Maintenance And Safety

OPERATION

Stopping the Engine

For maximum engine life, allow the engine to idle, without load, for 5 minutes. This will
allow the engine components that operate at high temperatures, such as the exhaust system,
to cool slightly before the engine is shut down.
1. Press the brake pedal until the utility vehicle comes to a complete stop.
2. HD and HD
PTO
the ground.
3. Move the gear selector lever to Park.
4. HD and HD
PTO
Disengage the PTO and make sure all rotating components are completely stopped.
5. Turn the engine off and remove the key to prevent unauthorized use.
NOTICE: A rolling vehicle can cause serious injury. Always place the gear selector lever in PARK
before stopping the engine.
Braking
1. Release the treadle pedal completely.
2. Press the brake pedal evenly and firmly.
3. Practice starting and stopping (using the brakes) until you're familiar with the controls.
Tip: When the treadle pedal is released, the vehicle hydraulic system will gradually slow the vehicle to
a stop. Use the brake pedal for faster stopping.

Driving Procedure

1. Wear eye protection.
2. Perform the pre-ride inspection. See page 33.
3. Sit in the driver's seat and fasten the seat belt.
4. Start the engine and allow it to warm up.
5. HD Model: Raise the attachment arm. See page
42.
6. Apply the service brakes and shift the
transmission into gear.
7. Check your surroundings and determine your
path of travel.
8. Keeping both hands on the steering wheel,
slowly release the brakes and depress the treadle pedal with your right foot to begin
driving. (Press the toe of the treadle pedal for forward travel, press the heel of the treadle
pedal for backward travel.)
9. Drive slowly. Practice maneuvering and using the treadle pedal and brakes on level
surfaces.
Tip: Allow the utility vehicle to come to a stop before changing directions with the treadle pedal.
10. Do not carry a passenger until you have at least two hours of driving experience with this
vehicle.
40
models only: Lower the attachment arm and put the attachment flat on
models only: Move the engine speed control lever to low idle.