Setting The Delay Time; Setting The Channel Level - Denon AVR-1906 Operating Instructions Manual

ENGLISH
Advanced Setup – Part 2
2 Parameters
Large:
Select this when using speakers that have sufficient ability to
reproduce bass sound below the frequency set for the
crossover frequency mode.
Small:
Select this when using speakers that do not have sufficient
ability to reproduce bass sound below the frequency set for the
crossover frequency mode. When this is set, bass sound with
a frequency below the frequency set for the crossover
frequency mode is sent to the subwoofer.
None:
Select this when no speakers are installed.
Yes / No:
Select "Yes" when a subwoofer is installed, "No" when a
subwoofer is not installed.
2sp / 1sp:
Set the number of speakers to be used for the surround back
channel.
If the subwoofer has sufficient low frequency playback
capacity, good sound can be achieved even when "Small" is
set for the front, center and surround speakers.

Setting the Delay Time

Input the distance between the listening position and each
speaker to set the delay time for the surround playback.
Preparations:
Measure the distances between the listening position and the
speakers.
FL Center
Subwoofer
SL
SBL SBR
1
Press the
"Delay Time" at the "Speaker Setup" menu,
then press the
• The "Delay Time" screen appears.
2
Press the
speaker to be set.
3
Press the
distance between the speaker and the listening
position.
The distance changes in units of 0.1 meters each time the
button is pressed. Select the value closest to the measured
distance.
If "Yes" is selected for "Default", the settings are
automatically reset to the default values.
The difference in distance for the various speaker
settings must not be greater than 6.0 meters.
4
Press the
• The "Speaker Setup" menu appears.
FR
Listening position
SR
CURSOR D D H H
or button to select
ENTER
button.
CURSOR D D H H
or button to select the
CURSOR F F G G
or button to set the
ENTER
button to enter the setting.
41
ENGLISH
Advanced Setup – Part 2

Setting the Channel Level

• Use this setting to balance the playback levels in different
channels and make them appear equal.
• From the listening position, listen to the test tones produced
from the speakers to adjust the level.
• The levels can also be adjusted directly from the remote control
unit ( page 42).
1 CURSOR D D H H
Press the or
"Channel Level" at the "Speaker Setup" menu,
ENTER
then press the button.
• The "Channel Level" screen appears.
2
CURSOR F F G G
Press the or
"Auto" or "Manual".
Auto:
Adjust the level while listening to the test tones produced
automatically from each speaker.
Manual:
Select the speaker from which you want to produce the test
tone to adjust the level.
3
CURSOR D D H H
Press the or
"TEST TONE Start", then press the
button to select "Start".
button to select
button to select
button to select
CURSOR F F