Page 1
Auto-Drive Ride-On Mower Owners Manual Please read this instruction manual carefully before operating your new Sanli Ride-On Mower. Model number: ADR1130...
Page 2
This warranty is in addition to your rights under the Australian Consumer Law. You will be provided with a refund, repair or exchange by Sanli for this product if it becomes defective within the warranty period. Sanli will bear the reasonable expense of claiming the warranty. This warranty will no longer apply where the defect is a result of alteration, accident, misuse, abuse or neglect.
15. Do not smoke when filling the fuel tank, using your ride-on mower, or when petrol is in the immediate area. And never use or store the ride-on mower near a naked flame. 16. Sanli recommends that you wear a safety helmet, ear protectors, safety goggles and safety boots when using your ride-on mower.
1. The seat/plate is attached to the mower chassis using the 2 x bolts and nuts supplied (fig 7). Position the seat/plate so that the holes are aligned with the holes on the mower chassis (fig Mounting bolts 7). Secure in place. 2. Connect safety switch wiring harness as shown in (fig 7a). Fig 7 Fig 7a Sanli Ride On Mower User Guide...
4. Ensure oil level is at the full mark on the dipstick, when screwed completely in. When finished replace dipstick and retighten. Fig 8 Fill Fuel Tank Use only clean, fresh 95 Octane regular unleaded petrol (must be less than 3 months old). 1. Using a clean funnel, fill tank with unleaded petrol. Replace cap (fig 9). 2. Wipe up any petrol that may have spilled. Fig 9 Adjusting the Seat In order to find the most suitable seating position, adjust seat by using the lever located on right side of seat (fig 10). Adjustment lever Fig 10 Sanli Ride On Mower User Guide...
Page 8
6. C utting Height Adjuster (fig 14) - Located right of seat with low cut at bottom and high cut at the top setting. Fig 14 7. C utter Drive (fig 15) - Lever located on left hand side of seat mounting box. Down position disengages blade drive and applies blade brake. Up position engages blades. Fig 15 Sanli Ride On Mower User Guide...
Moving these controls too fast could overload and stall the engine. WARNING: To avoid loss of control always come to a complete stop before changing drive direction and slow down before turning. Sanli Ride On Mower User Guide...
Proper care and maintenance is the responsibility of the owner. Oil Change Sanli recommends that you change your engine oil after the first 5 hours of use and then as per the schedule outlined in the engine manufacturer’s manual supplied with this machine. Spark Plug The spark plug gap gradually increases during engine running and should be checked periodically and whenever the engine malfunctions.
Lever located on left side of seat. General Wheel Base 135cm Length 164cm Width 80cm Height 95cm Turning Circle 5.8m Turning Radius 2.0m Weight 195kg Trouble Shooting Please contact your Authorised Sanli Ride-On Dealer for further details. Sanli Ride On Mower User Guide...