Setting The Raid Mode - DataWhale RS-M2TS User Manual

Setting the RAID Mode

Deleting the current partition prior to changing RAID modes is highly recommended.
eSATA/USB 2.0 model
Due to the chipset of the eSATA/USB 2.0 model, after deleting the current partition
and setting the new RAID mode, the reset button on the right side of the Mode switch
must be pressed in order for the updated RAID mode to take effect.
Pressing the reset button on first use of the RAID system is highly recommended.
USB 2.0 and USB 2.0/FireWire 800 models
For USB 2.0 and USB 2.0/FireWire 800 models, alternatively, after deleting the
current partition and turning off the power switch, set the new RAID mode, and power
the RAID system on again. The RAID system can then be used with the updated
RAID mode. Pressing the reset button is not required.
Power off the RAID System.
Use a small, flat-blade
screwdriver to select the
RAID Mode.
eSATA/USB 2.0 RAID
Modes
USB 2.0 RAID Modes
19