Table of Contents
Advertisement
3
Labels
3.1 FCC Statement
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to
part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful
interference in a residential installation. This equipment generates, uses, and can radiate radio frequency
energy, and if not installed and used in accordance with the instructions, may case harmful interference to
radio communications. However, there is no guarantee that interference will not occur in a particular
installation. If this equipment does cause harmful interference to radio or television reception, which can be
determined by turning the equipment off and on, the user is encouraged to try to correct the interference by
one or more of the following measures:
Reorient or relocate the receiving antenna.
●
Increase the separation between the equipment and receiver.
●
Connect the equipment into an outlet on a circuit different from that to which to receiver is connected.
●
Consult the dealer or an experienced radio/TV technician for help.
●
Use of shielded cord is required to comply with Class B limits in Subpart B of Part 15 of the FCC rules. Do not
make any changes or modifications to the equipment unless otherwise specified in the manual. If such
changes or modifications should be made, you could be required to stop operation of the equipment.
FCC Caution:
1.
The device complies with Part 15 of the FCC rules. Operation is subject to the following two
conditions:
o This device may not cause harmful interference.
o This device must accept any interference received, including interference that may cause undesired
operation.
2.
This Transmitter must not be co-located or operating in conjunction with any other antenna or
transmitter.
3.
FCC RF Radiation Exposure Statement This device has been tested for compliance with FCC RF
Exposure (SAR) limits. The equipment complies with FCC RF radiation exposure limits set forth for an
uncontrolled environment.
4.
Changes or modifications to this unit not expressly approved by the party responsible for compliance
could void the user authority to operate the equipment.
3.2 European Union CE Marking Declaration
This product has been tested and found to comply with the EMC requirements subject to the EU directive for
CE marking.
- 6 -
Advertisement
Table of Contents
