Pilot Burner Replacement - IDEAL Henrad WH 30 FF Installation And Servicing Manual

57 THERMOSTAT CONTROL, THERMISTOR SENSOR LEAD and ON/OFF SWITCH
REPLACEMENT
Refer also to Frame 54.
A. Remove the fixing screws
B. Swing the control box down into the servicing position.
Thermostat control
1. Pull the knob off the shaft.
2. Remove the backnut securing the thermostat control to
the control box.
3. Pull off the Molex connector from the printed circuit
board.
4. Replace and re-assemble in reverse order.
Thermistor sensor lead
5. Pull the sensor lead connector off the printed circuit
board.
6. Remove the sensor from the heat exchanger pocket
and unclip from the back panel.
7. Remove the strain relief bush from the back panel
base.
8. Remove the sensor lead through the grommet in the
control box.
9. Replace and re-assemble in reverse order.
On/off switch
10. Disconnect the electrical connectors from the rear of
the switch.
11. Press in the 2 side retaining clips and remove the
switch.
12. Re-assemble in reverse order.

58 PILOT BURNER REPLACEMENT

1. Refer to Frame 54.
2. Remove the burner and air box assembly.
Refer to Frame 49.
3. Remove the electrode retaining nut and remove the pilot
shield and electrode.
4. Unscrew the central pilot fixing screw and lift the pilot clear
of the pilot injector. The pilot injector may now be
unscrewed if required.
5. Replace the pilot burner (injector if necessary) and retain
with the M4 screw previously removed. Ensure that the
28
SERVICING
copper sealing washer is replaced when refitting the pilot
injector.
6. Replace the electrode and pilot shield, retaining both with
the electrode nut. Check the spark gap.
7. Reassemble in reverse order.
8. Check the operation of the boiler.
9. The pilot is factory set to maximum and no further
adjustment is possible. Ensure that there is an inlet
pressure of 20 mbar available. Also check burner ignition
and cross-lighting.
Henrad WH -
FF
Installation