Potentially Explosive Environments; Emergency Calls - Nokia E66 E series User Manual

Additional safety information
Potentially explosive
environments
Switch off your device when in any area with a
potentially explosive atmosphere, and obey all signs
and instructions. Potentially explosive atmospheres
include areas where you would normally be advised to
turn off your vehicle engine. Sparks in such areas could
cause an explosion or fire resulting in bodily injury or
even death. Switch off the device at refuelling points
such as near gas pumps at service stations. Observe
restrictions on the use of radio equipment in fuel
depots, storage, and distribution areas; chemical
plants; or where blasting operations are in progress.
Areas with a potentially explosive atmosphere are
often, but not always, clearly marked. They include
below deck on boats, chemical transfer or storage
facilities and areas where the air contains chemicals or
particles such as grain, dust, or metal powders. You
should check with the manufacturers of vehicles using
liquefied petroleum gas (such as propane or butane) to
determine if this device can be safely used in their
vicinity.
164

Emergency calls

Important: This device operates using radio
signals, wireless networks, landline networks, and
user-programmed functions. If your device supports
voice calls over the internet (internet calls), activate
both the internet calls and the cellular phone. The
device will attempt to make emergency calls over both
the cellular networks and through your internet call
provider if both are activated. Connections in all
conditions cannot be guaranteed. You should never
rely solely on any wireless device for essential
communications like medical emergencies.
To make an emergency call:
1. If the device is not on, switch it on. Check for
adequate signal strength. Depending on your
device, you may also need to complete the
following:
• Insert a SIM card if your device uses one
• Remove certain call restrictions you have
activated in your device.
• Change your profile from offline or flight profile
mode to an active profile.
2. Press the end key as many times as needed to clear
the display and ready the device for calls.