Help And Support - Memory-map Adventurer 3000 User Manual

13. Unplug the USB cable from the ADV3000 and then launch Memory-Map application. Tap Extended Menu (
by Settings & Overlays (
map you transferred should be displayed, tap on the map name.
14. You should then get a message stating the
the top right-hand corner of this window then close the Memory-Map application by tapping Exit (
to tap Extended Menu (
15. Connect your Adventurer 3000 to your PC with the supplied USB cable. Tap the Press to Connect button on the
Adventurer 3000 screen and it will connect to the PC as a removable drive.
16. Open the Memory-Map software on your PC and click Help > License Management... > SD Card... A window will appear
named Licenses for attached storage card which lists all the mapping/resources you can activate for the Adventurer
GPS.
17. Select the resource named GPS Features from the list so it becomes highlighted and then click the Activate... button.
If you are asked to log in enter your user name and password. You may be asked to give the SD card a name so that
you can recognise it later, so fill in a unique name for the card if prompted.
18. The status of the resource should change from '
be used with the Adventurer 3000, please refer to the Sending maps to the Adventurer 3000 section above for
instructions of how to send and activate your mapping on it.
Larger ready to use MicroSD cards for the Adventurer 3000 can be purchased from

Help and Support

For further help, guides and articles about the Adventurer 3000 please visit
ADV3000 User Guide v1.3
) and then tap Map... this will load up the Map List window. Tap the Refresh button and the
"license for resource GPS Features has not been activated",
) first).
None' 'Full, No Expiration'.
to Your new MicroSD card is now setup to
www.memory-map.co.uk/shop
www.memory-map.co.uk/support
) followed
tap on the X in
) (you may need
Page 16 of 16