NetAlert NetMeter User Manual page 2

Essentials
Read this first!
NetMeter requires 2 'AA' Alkaline batteries for viewing
measurements offline. NetMeter must be plugged into a
powered network to get most measurements. NetMeter
will run off DeviceNet network power, even without
batteries installed. Remember to install batteries if you
plan to use the Lock and offline viewing features.
AutoSearch Mode
AutoSearch mode saves you time by finding the network
measurements that exceed acceptable limits. It works by
examining all measurements and then pinpointing any
that exceed
each problem measurement NetMeter indicates the
measurement's switch position number in the upper left
corner of the display. Rotate the selector switch to the
indicated setting to view related measurements.
How to Use AutoSearch ...
1. Make sure the Lock switch is in the "Run" position and
turn the selector switch to AutoSearch
2. If you see
3. If you see
"Switch setting <Setting #>, <MIN> or <MAX> and/or
<P-P> is close to
Then press
bad/marginal value.To get more detail, turn the
selector switch to the indicated position and use the
buttons
DeviceNet Cable Essentials
CANL
(messages)
or are close to
- all measurements are within limits.
or then read the display like this ...
or Exceeds
and repeat the process for the next
to access related measurements.
Shield
CANH
(messages)
V+
(power)
specified limits. For
the spec limits."
DeviceNet cable
has five wires
inside. Each has a
specific purpose
which is referenced
in this manual.
V-
(power)
1
2