Initial Setup; Putting The Unit On A Proper Place - RCA RLDED5078A Instruction Manual

PUTTING THE UNIT ON A PROPER PLACE

When you turn on your television set for
the first time, be sure to place it on a solid
stable surface.
To avoid danger, do not expose the TV
to water, or a heat source
(e.g. lamp, candle, radiator).
Do not obstruct the ventilation grid
at the rear and be sure to leave sufficient
gaps around the unit.
TURNING THE UNIT ON FOR THE FIRST TIME
After you have initially connected your TV
antenna or cable,
turn the television ON.
A screen will display asking you to run a
Channel Auto Scan
available local digital channels.
It is here where you will select antenna options
and run Channel Auto Scan
Channels will be stored in the TV tuner.
Press the MENU button on the remote control.
Using the ◄ ► buttons, scroll to highlight
Press the ▼ button to highlight AIR/CABLE.
SOURCE SELECTION
1.Press the SOURCE button on the remote control.
2. Use the▲ or▼button to select the options
/AV,
(TV,Component
HDMI1,HDMI2,HDMI3 ,VGA)
and select any of them using the ► buttonor).
the ENTER button.
(The screen will change to your desired source
Note:
1. Before watching please make sure all necessary
cables and devices are connected.
2. When connecting the component or AV of DVD
devices, First select Component/AV, then the upper
right corner of the screen will display corresponding
Component or AV.

INITIAL SETUP

to search and receive
.
TV
Channel Auto Scan
mode.
12
Please run
INPUT SOURCE
TV
YPbPr/AV
HDMI1
HDMI2
HDMI3
VGA