Mx-Pb10 - Sharp MX-M283N Installation Manual

[14] MX-PB10

MX-M503N
1. Unpacking
A. Parts included
1
No. Packed part names
1 CD-ROM (Driver)
2 Product key sheet (With Application Number)
2. Installation
A. Preparation for enabling the MX-PB10
1) To enable the MX-PB10, enter the product key by the key
operation of the copier machine.
a) Press the system setting key on the operation panel.
b) Select [Product key input] key display page, and touch the
key.
c) Touch the input column.
d) Enter the product key with numeric key (10-key), and
touch [Registration] key.
2) After completion of entry of the product key, turn OFF the
power switch on the operation panel. Turn OFF the main
power switch, then turn ON the power switch and the main
power switch again.
3) Use the attached CD-ROM to install the driver.
For installing procedures, refer to the software setup guide.
Installation of the driver must be performed by the user or the
serviceman with assistance or the user.
Please keep below important information.
This information will use for other products.
APPLICATION
NUMBER
MACHINE
SERIAL
NUMBER
PRODUCT
KEY
2
Quantity
1
1
MX-M503N MX-PB10 14 – 1
Service Manual