Specifications; Important Safety Information - ICM Controls SC 2000 Installation, Operation & Maintenance Manual

Input:
• Voltage: Millivolt to 30 VAC/VDC
• DC Power: 3 volts (2 "AA" alkaline batteries included)
Output:
• Maximum: 1 amp per terminal (3 amp total for all terminals)
• Temperature control ranges: 45°F to 90°F (7°C to 32°C) Accuracy: ± 1°F (± 0.5°C)
• Differential range: 1°F to 3°F (0.5°C to 1.5°C)
• System configurations: Single-stage heat, single-stage cool
• Terminations: RC, RH, W, Y, O, B, G
• Always turn off the thermostat before installing, removing, cleaning, or servicing; turn off the power at
the main power source by unscrewing fuse or switching off circuit breaker
• Do not switch to "Cool" if room temperature is below 50 ° F (10 ° C); this could damage your A/C system
and cause injury
• Do not install on voltages higher that 30 VAC
• All wiring must conform to local and national building and electrical codes and ordinances
• While cleaning, do not get soap directly on thermostat switches or LCD readout; only use a damp cloth
with a mild soap to wipe outside of thermostat cover


Specifications

or single-stage heat pump, gas, oil,
electric

Important Safety Information

Room temperature
SET
setpoint
ROOM
Room temperature
LO BAT
Low battery signal
DIFF
Temperature
differential setting