Advertisement
• Torque driver
Be sure to use to fastening the mechanism and exterior parts
because those parts must strictly be controlled for tightening
torque.
• Bit
This bit is slightly longer than those set in conventional torque
drivers.
• Tweezers
To be used for removing and installing parts and wires.
• Chip IC replacement jig
To be used for replacement of IC.
• Cleaning cloth
Recommended the Cleaning cloth to wipe down the video
heads, mechanism (tape transport system), optical lens sur-
face.
• Guide driver (Hexagonal)
To be used for mechanism compatibility adjustment.
• INF adjustment lens
To be used for adjustment of the camera system.
For the usage of this tool, refer to the Service Bulletin No. YA-
SB-10035.
• INF lens holder
To be used together with the Camera stand for operating the
Videocamera in the stripped-down condition such as the sta-
tus without the exterior parts or for using commodities that
are not yet conformable to the interchangeable ring.
For the usage of this tool, refer to the Service Bulletin No. YA-
SB-10035.
• Camera stand
To be used together with the INF adjustment lens holder.
For the usage of this tool, refer to the Service Bulletin No. YA-
SB-10035.
• Light box assembly
To be used for adjustment of the camera system.
For the usage of this tool, refer to the Service Bulletin No. YA-
SB-10035.
• Gray scale chart
To be used for adjustment of the camera system.
For the usage of this tool, refer to the Service Bulletin No. YA-
SB-10035.
• Color bar chart
To be used for adjustment of the camera system.
For the usage of this tool, refer to the Service Bulletin No. YA-
SB-10035.
• Alignment tape
To be used for mechanism compatibility adjustment.
MC-1 [For NTSC model]
MC-2 [For PAL model]
• PC cable
To be used to connect the Videocamera and a personal com-
puter with each other when a personal computer is used for
adjustment.
QAM0099-001 [For J* model]
QAM0099-002 [For U* and K* models]
QAM0099-003 [For E* models]
QAM0099-005 [For A* models]
• Communication cable
Connect the Communication cable between the PC cable and
Jig connector cable when performing a PC adjustment.
3-2
• Service support system
To be used for adjustment with a personal computer. Soft-
ware can be downloaded also from JS-net.
• Jig connector cable
Connected to CN for Jig of the circuit board and used for elec-
trical adjustment, etc.
• Extension connector
Connect this extension connector to the connector of the Jig
connector cable for extending the cable connector.
Advertisement
