Accessories And Attachments - DeWalt DWE4011 Instruction Manual

4-1/2" (114.3 mm) Grinding Wheels
Type 27 guard
backing flange
Type 27 depressed
center wheel
threaded clamp nut

Accessories and Attachments

It is important to choose the correct guards, backing pads and flanges
to use with grinder accessories. See pages 9–10 for information on
choosing the correct accessories.
WARNING: Accessories must be rated for at least the speed
recom mended on the tool warning label. Wheels and other
accessories running over rated accessory speed may burst and
cause injury. Threaded accessories must have a 5/8"–11 hub. Every
unthreaded accessory must have a 7/8" arbor hole. If it does not, it
may have been designed for a circular saw and should not be used.
Type 27 guard
Type 27 hubbed wheel
Use only the accessories shown on pages 9–10 of this manual.
Accessory ratings must be above listed minimum wheel speed as
shown on tool nameplate.
Mounting Guard
cutting wheels, sanding flap discs, wire brushes, and wire
wheels. The tool may be used without a guard only when sanding
with conventional sanding discs. A Type 27 guard (intended for
use with depressed center grinding wheels [Type 27 and Type 29],
sanding flap discs, wire wheels and wire cup brushes) is available
at extra cost from your local dealer or authorized service center.
Grinding and cutting with wheels other than Type 27 and 29
require different accessory guards not included with tool. A Type
1 guard is provided for use with the Type 1 wheel. Mounting
instructions for accessory guards are shown below and are also
included in the accessory package.
Wire Wheels
Type 27 guard
3" (76.2 mm)
wire cup brush
CAUTION: Guards must be used with all grinding wheels,
Type 27 guard
4" (101.6 mm) wire wheel