Mercedes-Benz GLK 350 4MATIC Operator's Manual page 205

Glk-class
Hide thumbs Also See for GLK 350 4MATIC:
Table of Contents

Advertisement

sensor is intended for use in an automotive
radar system only. Removing, tampering
with, or altering the device will void any
warranties, and is not permitted by the
FCC. Do not tamper with, alter, or use in
any non-approved way.
Any unauthorized modification to this
device could void the user's authority to
operate the equipment.
Monitoring range of the sensors
In particular, the detection of obstacles can
be impaired if:
dirt on the sensors or anything else
R
covering the sensors
poor visibility, e.g. due to fog, heavy rain,
R
snow or spray
narrow vehicles, e.g. motorcycles or
R
bicycles
the road has very wide lanes
R
the road has narrow lanes
R
you are not driving in the middle of the lane
R
there are barriers or similar lane borders
R
Vehicles in the monitoring range are then not
indicated.
Blind Spot Assist monitors the area up to
10 ft (3 m) behind your vehicle and directly
next to your vehicle, as shown in the diagram.
If the lanes are narrow, vehicles driving in the
lane beyond the lane next to your vehicle may
be indicated, especially if the vehicles are not
driving in the middle of their lane. This may
be the case if there are vehicles driving at the
inner edge of their lanes.
Due to the nature of the system:
warnings may be issued in error when
R
driving close to crash barriers or similar
solid lane borders.
the warning is canceled when driving for an
R
extended period next to long vehicles, such
as trucks.
The two radar sensors for Blind Spot Assist
are integrated into the sides of the rear
bumper. Make sure that the bumper is free of
dirt, ice or slush in the vicinity of the sensors.
The sensors must not be covered, for
example by cycle racks or overhanging loads.
Following a severe impact or in the event of
damage to the bumpers, have the function of
the sensors checked at a qualified specialist
workshop. Blind Spot Assist may otherwise
not work properly.
Indicator and warning display
Blind Spot Assist is not active at speeds below
approximately 20 mph (30 km/h). Vehicles in
the monitoring range are then not indicated.
Yellow indicator lamp/red warning lamp
:
When Blind Spot Assist is activated, indicator
lamp : in the exterior mirrors lights up
yellow at speeds of up to 20 mph (30 km/h).
At speeds above 20 mph (30 km/h), the
I n f o r m a t i o n P r o v i d e d b y :
Driving systems
Z
203

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

Glk 3502014 glk class2014 x204Glk 250 bluetec

Table of Contents