Mercedes-Benz GLK 350 4MATIC Operator's Manual page 200

Driving systems
198
The 360° camera may show a distorted view
of obstacles, show them incorrectly or not at
all. It cannot show objects in the following
areas:
under the front bumper
R
very close to the front bumper
R
very close to the rear bumper
R
under the rear bumper
R
in close range above the handle on the
R
trunk lid
very close to the exterior mirrors
R
You are always responsible for safety, and
must always pay attention to your
surroundings when parking and
maneuvering. This applies to the areas
behind, in front of and beside the vehicle. You
could otherwise endanger yourself and
others.
The 360° camera will not function or will
function in a limited manner:
if the doors are open
R
if the exterior mirrors are folded in
R
the tailgate is open
R
in heavy rain, snow or fog
R
at night or in very dark places
R
if the cameras are exposed to very bright
R
light
if the area is lit by fluorescent light or LED
R
lighting (the display may flicker)
if you exit a heated garage in winter,
R
resulting in a rapid change in temperature
if the camera lenses are dirty or covered
R
if the vehicle components in which the
R
cameras are installed are damaged. In this
event, have the camera position and setting
checked at a qualified specialist workshop.
Do not use the 360° camera in this case. You
can otherwise injure others or cause damage
to objects or the vehicle.
Activation conditions
The 360° camera image can be displayed if:
your vehicle is equipped with a 360°
R
camera
COMAND is switched on, see the separate
R
COMAND operating instructions
the 360° Camera 360° Camera
R
Activating the 360° camera using the
SYS button
Press and hold the W button for longer
X
than 2 seconds, see the separate COMAND
operating instructions.
Depending on whether position D or R is
engaged, the following is shown:
full screen display with the image from
R
the front camera
full screen display with the image from
R
the rear camera
Activating the 360° camera with
COMAND
Press the W button, see the separate
X
COMAND operating instructions.
Select System System
X
COMAND controller and press W to
confirm.
Select 360° Camera 360° Camera
X
confirm.
Depending on whether position D or R is
engaged, the following is shown:
a split screen with top view and the
R
image from the front camera or
a split screen with top view and the
R
image from the rear view camera
For further information about the COMAND
controller, see the separate COMAND
operating instructions.
I n f o r m a t i o n P r o v i d e d b y :
function is activated
by turning cVd the
and press W to