Mercedes-Benz GLK 350 4MATIC Operator's Manual page 179

This speed may:
be too high if you are driving in a filter lane
R
or an exit lane
be so high when driving in the right-hand
R
lane that you overtake vehicles in the left-
hand lane
be so high when driving in the left-hand lane
R
that you overtake vehicles in the right-hand
lane
If there is a change of drivers, advise the new
driver of the speed stored.
If there is no vehicle in front, DISTRONIC
PLUS operates in the same way as cruise
control in the speed range between 20 mph
(Canada: 30 km/h) and 120 mph (Canada:
200 km/h). If a vehicle is driving in front of
you, it operates in the speed range between
0 mph (0 km/h) and 120 mph (Canada:
200 km/h).
Do not use DISTRONIC PLUS while driving on
roads with steep gradients.
As DISTRONIC PLUS transmits radar waves,
it can resemble the radar detectors of the
responsible authorities. You can refer to the
relevant chapter in the Operator's Manual if
questions are asked about this.
i
USA only:
This device has been approved by the FCC
as a "Vehicular Radar System". The radar
sensor is intended for use in an automotive
radar system only. Removing, tampering
with, or altering the device will void any
warranties, and is not permitted by the
FCC. Do not tamper with, alter, or use in
any non-approved way.
Any unauthorized modification to this
device could void the user's authority to
operate the equipment.
i
Canada only: This device complies with
RSS-210 of Industry Canada. Operation is
subject to the following two conditions:
1. This device may not cause harmful
interference, and
2. this device must accept any interference
received, including interference that may
cause undesired operation of the device.
Removal, tampering, or altering of the
device will void any warranties, and is not
permitted. Do not tamper with, alter, or use
in any non-approved way.
Any unauthorized modification to this
device could void the user's authority to
operate the equipment.
Cruise control lever
To store the current speed or a higher
:
speed
To store the current speed or a lower
;
speed
To deactivate DISTRONIC PLUS
=
To store the current speed or call up the
?
last stored speed
To set the specified minimum distance
A
Switching on DISTRONIC PLUS, storing
and maintaining the current speed
Activation conditions
In order to activate DISTRONIC PLUS, the
following conditions must be fulfilled:
the engine must be started. It may take up
R
to two minutes after pulling away before
DISTRONIC PLUS is operational.
the parking brake must be released.
R
®
R ESP must be active, but not intervening.
Active Parking Assist must not be
R
activated.
I n f o r m a t i o n P r o v i d e d b y :
Driving systems
Z
177