Hand-Held Steamer - Thane Housewares EP2120 User Manual

U S E R ' S G U I D E

HAND-HELD STEAMER

The Hand-Held Steamer is an ideal portable cleaner. It is there for you to detach and use on work surfaces, kitchen
countertops, sinks, bathrooms, windows, mirrors, tiles and spot cleaning on floor carpets and rugs. Use it with an
attachment (Optional Items) to spray away dirt, grease, mold, remove wrinkles from curtains, soft furnishings, and
more.
HOW TO USE HAND-HELD STEAMER
1) To release the Hand-Held Steamer.
a) Unlock the Hand-Held Steamer Body (Part 13) by lifting up the Hand-Held Steamer Body Lock (Part 7)
b) Push the Hand-Held Steamer Release button up (Part 6).
c) Detach the Hand-Held Steamer Body out.
2) To install the Short Jet Nozzle Attachment (Part 22)::
a) Ensure the Hand-Held Steamer (Part 13) has been
detached from the H20 Mop ® Ultra ™ Body (Part 8)
Adapter
c) Turn adapter (Part 23) to ensure channel opening is
accessible
e) Push Short Jet Nozzle attachment in the channel until it reaches the end, then turn clock-wise to lock it in place
NOTE:
To remove or replace attachments, rotate the attachment counter-clockwise and pull out.
b) Pull adapter (Part 23) out of channel
d) Align Short Jet Nozzle attachment to line up with
the corresponding slots inside the channel opening
8
3) Make sure that the water tank is full, refill if required. refer to page 6, (2) Fill the Water Tank.
4) Plug in the Power Cord to the grounded electrical outlet. RED light - Power Indicator (Part 10) will indicate
when power is on.
5) Wait for the Ready-to-use indicator (Part 11) to turn Green - approximately 30 seconds. GREEN light will be on
when the steam mop is ready for use. If the ON/OFF switch is pressed prior to ready light indicator turning
green, water from previous use will not be heated and will be forced out by present steam and will cause puddling
to occur. This may also happen if the ON/OFF switch was left in ON position from previous use and the unit was
disconnected by unplugging only.
Note: make sure to turn the unit OFF after each usage and then disconnect from an electrical outlet so the unit is
in OFF position when used next time.
6) When the Ready-To-Use indicator light turns green push the ON/OFF switch (Part 12) once to ON position as
illustrated in Fig 1.
The hand-held steamer will emit steam continuously. To stop emitting steam, press the ON/OFF switch (Part 12)
again and the switch button will come to OFF position as illustrated in Fig 2.
The hand-held steamer will stop emitting steam.
NOTE: During continuous use of the H2O Mop
green light indicates that the heater has reached its assigned temperature and when the green light goes off,
during use, it means that the heater is heating up again. However this will not affect the performance and you
may continue cleaning as usual.
It is normal that there may be some minor "spitting" of water mixed with the steam.
NOTE:
To sanitize your work surfaces, kitchen kitchen countertops, sinks, bathrooms, etc. Use the Hand-Held Steamer
over an area for about 15 seconds.
WARNING: Do not carry out this procedure on heat and steam sensitive surfaces.
The force and heat of the steam may adversely affect certain materials. Always check the suitability of using the
steamer on a surface by carrying out a preliminary test on a hidden area.
WARNING:
• Never direct steam towards people, animals and plants.
• Do not use the steam to clean frozen windows.
• Be careful when using the steamer on glass, as it may break.
• Do not use steamer on leather, wax polished furniture or waxed floors, synthetic fabrics, velvet or other
delicate steam-sensitive materials.
Thane Direct and its subsidiaries assume no liability for damage caused by use of the H2O Mop
its intended use or as instructed above and in the H2O Mop
Instructions" of the treated surface manufacturer.
Fig.2
Fig.1
Ultra the green light will go on and off – this is normal. The
® ™
Ultra
®
Ultra User Guide or outside of the "Use and Care
® ™
9
other than for
™