Customer Service - Ioline I/S 60 Quick Start Manual

12 Ioline SmarTrac Quick Start Guide
and pressing Test Cut until the pattern weeds easily and the blade
leaves a clear scoring on the backing.
To extend blade life, only set as much Force and blade exposure as
is absolutely required to get a clean cut and good weed. Reduce the
Force in small increments and perform more test cuts until the test
cut pattern sticks slightly while weeding; Then, set the Force to the
previous position. Press and hold the Test Cut key for 3 seconds. The
cutter will cut a large test pattern as a final check. Move the carriage
and material to a starting position for the first file. Press the Set Ori-
gin key on the keypad. The light on the keypad will turn green.
The cutter is ready to cut. Refer to the User Guide and
your design software documentation for more information
about optimizing cutter performance.

Customer Service

Ioline Corporation is committed to providing quality service and
support to our customers. If you need assistance with an Ioline prod-
uct, contact your local dealer or Ioline authorized service center. You
may also contact:
Ioline Customer Service Department
Monday through Friday
7:00 A.M. - 5:00 P.M. U.S. Pacific Time
Voice: 1.425.398.8282
Fax: 1.425.398.8383
support@ioline.com
www.ioline.com