Ioline I/S 60 Quick Start Manual page 8

8 Ioline SmarTrac Quick Start Guide
Tab
Back
Figure 9. Place cutter on cradle.
of the machine. Make sure that the holes line up. The media support
shaft fits in notches at the back of the cradle leg.
Figure 10. Insert Screws in legs or cradle feet.
Figure 11. Remove packing foam and plastic strip.
Place Cutter on
the Cradle
(optional on I/S 60)
Have one person
hold the cutter while
the other person posi-
tions the cutter. Slide
bottom tabs of the
Front cutter outside the top
of both cradle feet.
The longer portion
of the foot should
extend from the back
Insert the Screws
Have one person hold
the cutter while the
other person inserts
the screws to secure
the cutter to the legs or
cradle feet. Insert the
/ -in (short) Phillips
3
8
head screws though
the leg or cradle foot
and into tabs on the
cutter; Tighten.
Finish Assembly
Cut the plastic strap
that holds the car-
riage in place during
shipment and discard
it. Remove and dis-
card all packing foam
from around the car-
riage to complete the
assembly.