Ioline I/S 60 Quick Start Manual page 9

Step 4: Finish Installation
Connect the
Machine Cables
Make sure power is
off to the cutter (the
switch is placed in the
0 position). Connect
the serial or USB cable
and the power cord
to the panel on the
back of the right side
of the cutter. Plug the
machine power cable
into a wall socket or
surge protector.
Connect the
Computer Cable
With power to the
computer off, connect
the serial or USB cable
to one of the ports
on the back of the
computer. See the In-
stallation chapter of the
SmarTrac User Guide
for more information.
Install the
Software
Insert the installation
CD-ROM into the
computer CD-ROM
drive. The install
program should start
automatically. If it
does not, select Run
from the Start Menu.
Browse to the CD-
ROM and double-click
on Install Ioline Con-
trol Center from the
list of options. Press
OK to start the install.
Install the Control
Center software.
Install USB Drivers
Please see the guide labeled Installing USB Drivers for Ioline Products
on the CD-ROM for the driver installation process.
Power Serial
Cable Port
Figure 12. Power cable and communication ports.
USB Ports
Serial Port
Figure 13. Computer communication ports.
Figure 14. The Ioline Control Center.
USB
Port
Quick Setup
i
Note
A USB cable is provided in the
Accessory Kit.
i
Note
An adapter (not included) is re-
quired for 25-pin serial connections.
i
Note
The Setup program also allows
installation of the electronic User
Guides and the necessary viewer.
9