Mitsubishi Electric PU(H)Y-P250YGM-A Service Handbook page 64

<Model 250>
Heat exchanger
(liquid pipe)
Heat exchanger
(gas pipe)
Drain pan
<Model 500>
Heat exchanger
(liquid pipe)
Heat exchanger
(gas pipe)
Drain pan
Note
1. Peel off the pipe cover carefully. The cover will be needed again when putting the units together.
2. When loading the unit on an elevator, place the separated sections upright as shown below.
(Place the right side up.) Place a piece of wood at the bottom of the bottom section for support to keep it level.
<Model 250>
Top
Control box
Fan
Motor
Supporting
Bottom
wood piece
Bottom section of the unit
[Fig. 3]
<Model 500>
Top
Control box
Heat exchanger
Piping side
Bottom
Top section of the unit
- 55 -
Unbraze these sections
(2 places on the gas pipe/
expanded part)
Top
Fan
Motor
Supporting
Bottom
wood piece
Bottom section of the unit
[ IV Indoor Unit Components ]
Unbraze this section
(1 place on the liquid pipe/
upper part of the strainer)
Unbraze these sections
(2 places on the liquid pipe
/upper part of the strainer)
Unbraze these sections
(2 places on the gas pipe
/upper part of the strainer)
Top
Heat exchanger
Piping side
Bottom
Top section of the unit