Connecting The Camera Cables; Left Side - Cisco TelePresence SpeakerTrack 60 Installation Manual

Connecting the camera cables

It can be a bit cramped when you connect and secure the cameras, so you'll probably
want to inspect the camera connector panel to know where the HDMI, Ethernet and power are
located.
Connect one HDMI cable
to each camera. The HDMI
cables for the two cameras
are going to the codec.
Start with the camera to the right and hold the camera as illustrated. Make sure the short cables
(Ethernet and power) are available for this camera and connect the cables. Then connect the
HDMI cable coming from the codec. Guide the camera into position.
Proceed with the camera to the left and hold the camera the same way as you did with the first
camera. Connect the long cables (Ethernet and power) to the left camera. Connect the HDMI
cable coming from the codec. Guide the camera into position.
Left
side
78-100223-02C0 | MARCH 2015.
Copyright © 2015 Cisco Systems, Inc. All rights reserved.
The Ethernet and power
cables are coming from the
base unit. The short cables
goes to the right camera and
the longer cables to the left
camera.
3,0A
Right
side