Deck And Striding Belt - Life Fitness 4000 Service Manual

Life Fitness Model 4000 Treadmill
How To ... REMOVE AND REPLACE THE DECK AND STRIDING BELT
Tools Required: Phillips Screwdriver, socket set, hex key wrench set
IMPORTANT: THE DECK AND STRIDING BELT SHOULD ALWAYS BE REPLACED IN TANDEM.
Remove the FRONT ROLLER ASSEMBLY. (See "How To...").
Step 6
Use a hex key wrench to loosen and remove the four SCREWS securing the top of the DECK to the FRAME
ASSEMBLY.
Step 7
Remove the worn DECK and STRIDING BELT from the FRAME ASSEMBLY.
Step 8
Position a new DECK and STRIDING BELT in place and reverse Steps 1 through 6 to return all parts to their
proper locations. Refer to "How to...ADJUST AND TENSION THE STRIDING BELT" for proper BELT tensioning
instructions
NOTE: DO NOT OVERTIGHTEN THE TENSIONING BOLTS TO AVOID DAMAGE TO
DO NOT REPLACE ONE WITHOUT THE OTHER.
THE STRIDING BELT AND THE ROLLER BEARINGS.
Step 1
Turn the power OFF at the ON/OFF switch and then unplug
the unit from the electrical outlet.
Step 2
Remove the MOTOR COVER. (See "How To...").
Step 3
Use a phillips screwdriver to remove the three SCREWS
securing each of the END CAPS to the Treadmill FRAME.
Remove the END CAPS and set aside.
Step 4
Remove the REAR ROLLER from the machine.
(See "How To...").
Step 5
5