Table of Contents
Advertisement
1.2 Guidelines for the operator
WARNING
Operators must be fully trained in the use
of the machine in accordance with these
instructions, able to perform user maintenance
and the correct selection of accessories.
• Operators should be physically capable to
manoeuvre,
transport
machine.
• Operators should be able to recognise unusual
operation of the machine and report any
problems.
• Only use the machine on firm level surfaces.
• Wear suitable footwear to avoid slipping.
• Wear suitable clothing to keep dry and warm.
• Where possible implement job rotation and
adequate rest periods to avoid continuous use
of the same muscles.
• Do not leave machine running unattended
• Do not smoke when using the machine.
• Do not put any objects into openings. Do not
use with any opening blocked: keep free of
dust, debris, hair, or anything that may reduce
air flow.
CAUTION - This machine is for indoor
use only and should not be used or
stored outdoors or in wet conditions.
CAUTION - If it is suspected that there is
hazardous dust or flammable materials
stop cleaning the area
consult your superior.
WARNING Only use accessories and
spare parts provided with the machine or
those approved by the manufacturer.
The use of other accessories may impair
the safety of the machine.
WARNING – Should water emit from the
machine
exhaust
immediately and refer to instructions for
Using the Machine
• Ensure the machine is switched off before
adding or changing accessories.
1.3 Transporting the machine
CAUTION – Incorrect lifting techniques
may result in personal injury, where
applicable do not lift large and heavy
machines without assistance. We advise that the
manual handling regulations are followed.
Please refer to the technical table for details on
weight of machine.
When transporting the machine ensure that all
components, tanks and removable parts are
securely fastened, and that the supply cord and
plug are not trailing. Detach hose and wand from
machine where applicable.
and
operate
the
immediately and
switch
off
5
Do not lift or transport the machine whilst
containing liquid as this will add considerably to
the weight.
Take extreme care when moving the machine up
or down steps or stairs.
1.4 Electrical connection
Before connecting the machine to the power
supply,
check
that
corresponds with that marked on the rating label.
The power supply cord plus any extension leads
should not exceed 30m in total, otherwise you
may experience
problems
machine. The cross-section of any extension
cable wiring must be at least 2,5 mm
Should an extension cord be used, ensure cord
rating is adequate for the equipment. Do not use
extension cord in coiled condition as this could
result in overheating of the cord.
UK only
The supply cord for 230v models is fitted with a
plug containing a 13 amp fuse. Should the fuse
require replacement it must only be replaced by a
13 amp fuse conforming to BS1362, and the fuse
cover must be refitted. If the fuse cover is lost the
plug must not be used until the correct
replacement cover is fitted.
IMPORTANT - If the supply cord is damaged, it
must only be replaced by a special cord available
from the manufacturer or an authorised service
agent.
WARNING – THIS APPLIANCE MUST BE
EARTHED
1.5 Symbols & Markings
WARNING
Earth symbol
your
supply
voltage
starting
up
the
².
Advertisement
Table of Contents
