Salvador Escoda MUCSW-16-HG Operation And Installation Manual page 41

8) External auxiliary drain pan installation
1. Insert the water delivery tube of the external drain pan into the pre-cut hole on the unit body.
2. Align the 2 installation screw position and fix the external drain pan.
9) Electrical connection
1. Remove control box cover and refer to the wiring diagram label on the back of the cover.
2. The PCB, transformer, motor capacitor, terminal are installed inside the control box.
3. To connect wires properly.
4. Recheck the PCB jumper and switch set properly as per wiring diagram sticker shown.
5. After wiring, install control box cover
10) Mounting unit panel
1. Unlock the fastener on the air return grille. Remove the air return grille from unit panel.
2. Move the unit panel to casing. Tighten 4 screws.
3. Reassemble the air return grille.
17