Salvador Escoda MUCSW-16-HG Operation And Installation Manual page 35

9) Fan speed setting
FAN
Press button to change the fan speed, only low speed available for dehumidification mode.
10) On/Off control
Press to start or stop the air conditioner.
11) Networking control (only master unit wall pad can control slave units on the network)
NET
Press button to enter into networking control mode. Unit area blinking indicates the slave unit under
TI M E
control. Press
automatically.
NET
Press button again to exit networking control mode.
Parameters that can be controlled are on/off, timer weekly program, set temperature, mode, fan speed, swing and
sleep, operation methods are the same as above.
Hold down
same to exit global control mode. In global control mode, the setting of master unit will broadcast to all the slave
units.
TI M E
or to select the desired slave unit. Units that are offline will be skipped
FRESH
and buttons for 3 sec to enter into Global control mode,
11
lights up. Repeat the