Operating The Spa Controls - InnovaSpa Urbania Standard 110 Owner's Manual

OPERATING THE SPA CONTROLS

PUMP OPERATION
The spa pump will operate at two different speeds. This enables you to control the intensity of the spa jets.
To change the pump speed, simply depress the jets icon on the top side control. The icon has three
positions. Low speed, high speed and off.
OZONE WATER CLEANING SYSTEM
If your spa is equipped with an ozone water cleaning system, it will be located in the equipment cavity. It
operates automatically and only when the spa pump is running on low speed. When it is on, the ozone
cylinder will emit a bluish green light. It is recommended that you check for this light on a regular basis to
ensure that the ozone system is functioning properly.
SPA JETS
All therapy jets in the spa are individually adjustable. By turning the jets clockwise or counter clockwise, you
can control the intensity of the water flow. By turning the jets clockwise, you will reduce the water flow until
the jets are completely shut off. By turning them counter clockwise you will increase the water flow until the
jets are in their wide open position. If your spa is equipped with a turbo jet, there will be a large control valve
located on the top of the spa, by the top side control. By turning this valve counter clockwise, you will direct
water flow from the therapy jets to the turbo jet. The therapy jets will lose their intensity until they are
completely off when the turbo jet is in its full open position. By turning the valve clockwise, the turbo jet
intensity will decrease and the intensity of the therapy jets will increase again.
AIR CONTROL VALVES
There are two air control valves located on the top of the spa, beside the filter lid. Each valve controls air flow
to the therapy jets at each end of the spa. By opening and closing these valves, you can regulate the amount
of air that will mix with the water that is entering the spa through the jets. This will change the intensity of the
jet action. When you are not using your spa, it is critical to ensure that these valves are in their closed
positions. This prevents cold, ambient air from entering the spa water when the spa is operating in filter or
heating mode and it makes spa operation more energy efficient.
WATERFALL
If your spa is equipped with a waterfall, there will be a control valve located beside it. By opening and closing
this valve, you can control the flow of water cascading from the waterfall. The waterfall will only operate when
the jet pump is operating.
LIGHTING
If your spa is equipped with a standard main spa light, you can turn it on and off by depressing the light icon
on the top side control. If your spa is equipped with an LED light package, your spa will have an LED main
light and 10 LED's located on the top of the spa, underneath the waterfall and outside the spa to illuminate the
spa entry step. By depressing the light icon, you can change the light colors and the mode of operation.
Page 10