Appendix; Replacing The Battery; Enabling The Internal Heater; Factory Data Reset - Panasonic FZ-E1 series Operating Instructions Manual

Appendix

Replacing the battery

Replacing the battery
Place the unit on a flat, stable surface such as a table when replacing
the battery.
1. Turn off the unit (page 42).
2. Remove the battery cover (page 35).
3. Lift the battery by pulling on the yellow tab, and then remove the
battery.
4. Install the replacement battery (page 40).
5. Attach the battery cover (page 36).
Hot swapping the battery
The unit supports "hot swap" battery replacement, which allows you
to replace the unit's battery without turning the unit off.
• Be sure to finish the battery replacement in 30 seconds.
Otherwise, the unit may turn off. In this case, any data which has
not been saved will be lost.

Enabling the internal heater

Enabling the internal heater
If enabled, the unit's internal heater will activate in order to warm the
product when its temperature is -12 °C or colder.
1. Flick the Start screen to the left, and then in the App list, tap
[Settings] → [other settings].
2. Set the [Heater] switch to [Auto] or [Off].

Factory data reset

Factory data reset
CAUTION
• The following procedure resets all settings and erases any data
you have stored in the unit. Back up important data before
performing this procedure.
1. Flick the Start screen to the left, and then in the App list, tap
[Settings] → [about].
52