Sony MHC-GZR8D Operating Instructions Manual page 123

The surround effect is difficult to hear
when you are playing a Dolby Digital
or MPEG audio sound track.
 Make sure the sound field is set
properly (page 95).
 Check the speaker connection
(page 23).
 Depending on the DVD VIDEO, the
output signal may not be the entire 5.1
channel. It may be monaural or stereo,
even if the sound track is recorded in
Dolby Digital or MPEG audio format.
The sound loses stereo effect when
you play back a DVD VIDEO, VIDEO
CD, AUDIO CD, MP audio track or
DivX video file.
 Unplug the microphone or press
KARAOKE MODE
"" disappears from the display.
 Make sure the system is connected
properly.
 Check the speaker connection
(page 23).
USB device
You cannot start transferring or
recording to an USB device.
 The following problems may have
occurred.
 The USB device is full.
 The number of tracks and folders
on the USB device has reached the
upper limit.
 The USB device is write-protected.

repeatedly until
Transferring or recording is stopped
before it is finished.
 You are using an unsupported
USB device. Refer to "Compatible
USB devices" (supplement) for the
supported device types.
 The USB device is not formatted
correctly. Refer to the operating
instructions supplied with the USB
device for how to format.
 Turn off the system and remove the
USB device. If the USB device has a
power switch, turn the USB device
off and then on again after removing
it from the system. Then perform
transferring again.
 If the transfer, recording and erase
operations are repeated multiple times,
the file structure within the USB device
becomes fragmented. Refer to the
operating instructions supplied with
the USB device for how to deal with
this problem. If the problem persists,
contact your nearest Sony dealer.
Transferring or recording results in
an error.
 You are using an unsupported
USB device. Refer to "Compatible
USB devices" (supplement) for the
supported device types.
 Turn off the system and remove the
USB device. If the USB device has a
power switch, turn the USB device
off and then on again after removing
it from the system. Then perform
transferring again.

Continued
1
GB