Care And Maintenance; Tyre Pressure; Wheel Replacement; Cleaning And Disinfection - Pride Mobility Go-Go ELITE TRAVELLER Owner's Manual

I X . C A R E A N D M A I N T E N A N C E
Your Travel Scooter requires a minimal amount of care and maintenance. If you do not feel confident in your ability
to perform the maintenance listed below, you may schedule inspection and maintenance with your authorised Pride
Provider. The following areas require periodic inspection and/or care and maintenance.

TYRE PRESSURE

! If equipped with pneumatic tyres, always maintain the psi/bar/kPa air pressure indicated on each tyre.
WARNING! It is important that the psi/bar/kPa air pressure indicated on each tyre be maintained
in pneumatic tyres at all times. Do not underinflate or overinflate your tyres. Low pressure may
result in loss of control, and overinflated tyres may burst. Failure to maintain the psi/bar/kPa air
pressure indicated on pneumatic tyres at all times may result in tyre and/or wheel failure.
! Regularly inspect your Travel Scooter's tyres for signs of wear.

WHEEL REPLACEMENT

If your Travel Scooter is equipped with pneumatic tyres and you have a flat tyre, you can have the tube replaced.
If your Travel Scooter is equipped with a solid tyre insert, either the solid insert or the entire wheel must be
replaced depending on model. Contact your authorised Pride Provider for information regarding replacement
wheels for your Travel Scooter.
WARNING! Wheels on your Travel Scooter should only be serviced/replaced by your
authorised Pride Provider or a qualified technician.
WARNING! Completely deflate pneumatic tyres before dismantling the rim or attempting
repair.
WARNING! When changing a tyre, remove only the centre lug nut, then remove the wheel.
If any further disassembly is required, deflate the tyre completely or it may explode.
EXTERIOR SURFACES
Bumpers, tyres and trim can benefit from an occasional application of a rubber or vinyl conditioner.
WARNING! Do not use a rubber or vinyl conditioner on the Travel Scooter's vinyl seat or
tyre tread, as they will become dangerously slippery.

CLEANING AND DISINFECTION

! Use a damp cloth and mild, non-abrasive cleanser to clean the plastic and metal parts of your Travel Scooter.
Avoid using products that may scratch the surface of your Travel Scooter.
! If necessary, clean your product with an approved disinfectant. Make sure the disinfectant is safe for use on
your product before application.
WARNING! Follow all safety instructions for the proper use of the disinfectant and/or cleaning
agent before applying it to your product. Failure to comply may result in skin irritation or
premature deterioration of upholstery and/or Travel Scooter finishes.
Elite Traveller www.pridemobility.com 35