Table of Contents
Advertisement
1. Disconnecting the STOP terminal from the COMMON terminal stops the gate and prevents all
commands from having any effect. Manual Open does not activate the Reclose Timer.
2. If gate(s)are used for bi-directional traffic, the Exit Loop should be a directional loop detector.
3. Inside and Outside Interrupt Loops:
For maximum safety, Inside and Outside Interrupt loops require separate loop detectors.
If only one loop detector is used, the Outside loop must also be connected to the Inside
loop detector.
To enhance system safety in Bi-Parting and Bi-Parting Latch Master/Slave systems, the
Interrupt loops, Shadow loops and Interrupt Bar switches may be connected to both gates.
If this is done, when connecting the two control boards, do not interchange input and
common terminals. If terminals are interchanged, inputs will not be detected and controller
boards may be damaged. For more information, see Installation and Operation of
Master/Slave Systems for Series B1 Gate Operators Doc. No. 6001378
M.
SETTING GATE CONTROL SWITCH S1 AND RECLOSE TIMER POT R94
NOTE: For complete details on controls, indicators adjustments and inputs, see Appendix A.
1. GATE CONTROL SWITCH (S1)
SLIDE ACTION
When used with ATG, this switch controls several gate operator features:
(S1-1)
Inside Interrupt Loop: four different modes are selectable:
SLIDE and ATG OFF: Loop activation prevents the gate from opening or closing. If
gate is moving, Loop activation stops the gate. When the Loop clears, the gate
resumes its course.
SLIDE only ON: Loop activation prevents the gate from closing. If gate is closing,
Loop
activation opens the gate and starts the Reclose Timer, if timer is ON.
ATG only ON: Loop activation prevents the gate from opening or closing. If gate is
closing, a Loop activation stops the gate. When the Loop clears, the gate resumes
closing. If the gate is opening or fully open, as soon as the Loop clears, the gate
immediately begins closing to discourage tailgaters.
SLIDE and ATG ON: Loop activation prevents the gate from closing. When the Loop
clears, the gate resumes closing. If gate is opening or fully open, as soon as the
Loopclears, the gate immediately begins closing to discourage tailgaters.
Dynamic Braking:
Rev C
NOTES
Figure 10. Gate Control Switch S1 Location.
When SLIDE is ON, gate brakes whenever it stops.
When SLIDE is OFF, gate brakes only at open or close limit.
Doc 6001287 (01-20284)
14 of 40
Advertisement
Table of Contents
