Safety Warning - Black & Decker CD600 Manual

FEATURES
1. Sawdust outlet
2. Window lever
3. Depth of cut adjustment
4. Guard retracting lever
5. Saw blade locking screw
6. Riving knife (not included on Australian and
New Zealand models)
7. Blade guard
8. Parallel fence
9. Window
10. Front handle
11. Carbon brush cover
12. Mitring angle scale
13. Locking screw for mitring adjustment
14. Saw shoe
15. Locking screw for parallel fence
16. Sight guide
17. Mark for straight cut
18. Mark for mitring cut
19. Electronic switch (electronic models only)
20. On/off switch
21. Depth of cut scale
22. Secondary locking lever for mitring adjustment
23. Inner washer
24. Outer washer
25. Lock-off button
26. Blade
KS846N, KS850N, KS855N, KS865E/N/KN, 374456N
•
1
•
•
2
3
•
•
4
5 •
•
6
7
•
8
•
CD600, KS227, KS840
1
•
3
•
4
•
5
•
•
6
•
7
•
8
CD600 Circ saw UK/Auz/NZ
Your product includes some or all of these features.

SAFETY WARNING

Your saw is designed for use with wood cutting blades
only. Do not use stone cutting or metal cutting discs.
PREPARING YOUR CIRCULAR SAW
SETTING THE DEPTH OF CUT ADJUSTMENT
Proceed as follows:
Disconnect the plug from the electricity supply.
than the thickness of the workpiece.
SETTING THE SIGHT GUIDANCE SYSTEM
(NOT KS227/KS840/CD600)
The window and 'sight guide' are designed to enable
accurate cutting everytime the saw is used.
To prepare the guide system for first time use,
proceed as follows:
9
•
10
•
11
• 12
13
•
14
•
•
15
•
16 (17+18)
19
•
• 25
•
20
• 10
12
•
13
•
14
•
•
15
and secure in place with the screw provided.
•
17+18
• At the start of every cut align the blade as described
7
Loosen the depth of cut
adjustment (3) at the
3
bottom of the scale.
Move your circular saw
•
up the scale until the
21
• desired depth of cut is
indicated on the scale
(21). Tighten the screw
•
(3). The depth of cut
22
should be 3mm greater
Mark a straight line on
your workpiece to
represent the desired
path of the saw blade.
Whilst viewing through
the saw guard window
align the saw blade teeth
with the intended line of
cut drawn on the
workpiece.
Whilst keeping the saw
in this position, place the
•
orange 'sight guide' (16)
16
onto the shoe of your
circular saw. Align the
'sight guide' with the line
drawn on the workpiece
and whilst cutting keep the 'sight guide' in line with
the intended line of cut drawn on the workpiece.
15/3/00, 5:20 pm
ENGLISH
7