Download
Share
Print this page
  1. Manuals
  2. Brands
  3. Central Pneumatic Manuals
  4. Nail Gun
  5. 98751
  6. Startup manual

Central Pneumatic 98751 Startup Manual

3 in 1 air framing nailer
Hide thumbs Also See for 98751:
1
2

Advertisement

Quick Links

Download this manual
98751
1.
Even though the Nailer should be empty during the following procedure, ALWAYS point the Nailer at a
piece of scrap wood when testing.
2.
Make sure Trigger and Safety Nosepiece move freely, without sticking. Do not use nailer if Trigger or
Safety sticks.
3.
Disconnect the Nailer from the air compressor whenever loading or servicing.
4.
WEAR ANSI-APPROVED IMPACT SAFETY GOGGLES WHEN RELOADING OR DOING ANY OTHER
MAINTENANCE ON NAILER. Other people in work area must also wear ANSI-approved safety goggles.
5.
This guide is not intended to replace the Manual. READ THE MANUAL.
Testing The Safety Mechanism
1. Completely empty the Magazine.
2. The Nailer should not fire if Safety Nosepiece is not depressed against scrap wood.
3. Connect air supply to the Air Coupler. Set the regulator at the recommended 70 to 120 PSI.
4. Test by depressing Safety Nosepiece against a piece of scrap wood without pulling the Trigger.
The Nailer must not fire. If it fires, stop immediately and have the Nailer repaired by a qualified
service technician.
5. Hold tool away or off of scrap wood. The Safety Nosepiece should return to its original position.
Squeeze the Trigger. The Nailer must not fire. If the tool fires, stop immediately and have it repaired
by a qualified service technician.
6. Depress Safety Nosepiece against workpiece and squeeze Trigger. The Nailer must fire only once.
Release the Trigger and squeeze it again. The Nailer must not fire.
With the Trigger held, carefully lift the Nailer and press it against the workpiece again.
The Nailer must not fire. If it fails to perform in the manner explained in bold, have the Nailer
repaired by a qualified service technician.

Loading Nails

1. Slide the Tab back and the Lock will hold it in place.
2. Load a stick of nails (not included) into the top slot,
making sure nail heads are facing up.
To prevent injury when releasing the Lock, KEEP FINGERS CLEAR OF TAB TRACK.
Tab automatically and forcefully slides forward. PINCH HAZARD.
The Nailer may not work if there are only a few nails left in the tool.
If there are only a few nails remaining, simply load another strip of nails into the Magazine behind the few
3 IN 1 AIR FRAMING NAILER START-UP GUIDE
remaining nails. The Nailer will be ready for further use.
WARNING
To prevent serious injury:
CAUTION
NOTICE
Tab
Page 1

Advertisement

loading

Related Manuals for Central Pneumatic 98751

Summary of Contents for Central Pneumatic 98751

  • Page 1: Loading Nails

    3 IN 1 AIR FRAMING NAILER START-UP GUIDE 98751 WARNING To prevent serious injury: Even though the Nailer should be empty during the following procedure, ALWAYS point the Nailer at a piece of scrap wood when testing. Make sure Trigger and Safety Nosepiece move freely, without sticking. Do not use nailer if Trigger or Safety sticks.
  • Page 2 3 STEPS TO SET NAILER ANGLE Washer CAUTION 34° 28° 21° To prevent injury, disconnect the air supply before making adjustments. Hex Bolt Trigger Hex Bolt Adjustment Holes Lock Bar Guide Depth Screw Bracket CAUTION Tab Track Inspect Pin’s location. To prevent injury when releasing the Lock, KEEP FINGERS CLEAR OF TAB TRACK.