Table of Contents
Advertisement
SETTINGS
11
For the advanced setting (the setting of the
Ethernet connection speeds), press
./T
to
select "Yes" or "No", then press ENTER.
• Normally select BNo". then press ENTER.
• Tl,e Etllernet connection speeds can be set when you
select BYes", then press ENTER.
• As automatic detection is made (factory preset
mode), this setting is not normally necessary. If a
situation occurs in which the Ethernet connection fails
etc .. change the setting and confirm if the Ethernet
connection successfully works.
When the connection speed is set. select "Next", then
press ENTER.
12
For testing the connection to the internet, after
confirming the settings, press
./T
to select
"Test", then press ENTER.
• "Test" is available only when setting to obtain the IP
address automatically. "Test" cannot be selected if the
IP address has not been obtained automatically.
• As a result of the test, if the internet connection fails,
enter the setup values manually.
13
Press
./T
to select "Complete", then press
ENTER.
I
en
CD
:=
5'
IC
CIl
@-
43
Advertisement
Table of Contents
