Disc Playback; Before Starting Playback; Loading The Batteries In The Remote Control; Approximate Operating Range Of Remote Control - Sharp BD-HO52U Operation Manual

Table of Contents

Advertisement

Disc Playback
Before Starting Playback
Loading the Batteries in the
Remote Control
Approximate operating range of
remote control
C
iii'
(')
"tJ
iii
'<
CT
III
(')
~
• Remote control unit
E~Ri~;
0 0 ; 0 ;
CD 0 0t1,.
0oo8
00.0'A!
,00,0,10
i'~'~'.~<~!
i
0=ctJ!
,......
-
..
",
0c=J0
888
i)C0(§
6666
0 0 0 0
-
"'~r-""c'
,~
,
30°
30°
7m
Connecting the Power Cord
Plug the supplied AC cord into the AC IN terminal on
the rear of the Player. Then plug into AC outlet.
Remote control sensor
eE<._s;~
, ' - ----r----
,
.
Load the two "AA" size batteries (R-06 size,
UM/SUM-3). Place batteries with their terminals
corresponding to the
(±)
and
8
indications in
battery compartment.
f~~)®
" " ' - 8
Insert the smaller tab of the battery cover into
the opening
CD,
and press down on the cover
until it clicks in place
®.
2
3
1
Hold in the tab on the battery cover and pull the
cover towards the direction of the arrow.
~NOTE
• Do not subject the remote control unit to shock, water or
excessive humidity.
• The remote control unit may not function if the Player's
remote sensor is in direct sunlight or any other strong light.
• Incorrect use of batteries may cause them to leak or burst.
Read the battery warnings and use the batteries properly.
• Do not mix old and new batteries, or mix different brands.
• Remove the batteries if you will not use the remote control
unit for an extended period of time.
~! WARNING - - - - - - - - - - -
• Do not use or store batteries in direct sunlight or other
excessively hot place, such as Inside a car or near a heater.
This can cause batteries to leak, overheat, explode or
catch fire.
It can also reduce the life or performance of batteries.
To AC IN terminal
To AC outlet
~NOTE
• Place the Player close to the AC outlet, and keep the
power plug within reach.
• TO PREVENT RISK OF ELECTRIC SHOCK, DO NOT
TOUCH THE UN-INSULATED PARTS OF ANY CABLES
WHILE THE AC CORD IS CONNECTED .
• The ON/STANDBY indicator blinks while the Player is
preparing for starting up. You cannot turn the Player on
until the ON/STANDBY indicator stops blinking.
• If you are not going to use this Player for a long period of
time, be sure to remove the AC cord from the AC outlet.
@-
19

Advertisement

Table of Contents
loading

Table of Contents